Arduino Motor Controller: Difference between revisions
From olighker
More actions
首页卡片独立产品迁移 |
No edit summary |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
{{ProductInfo | |||
|title=OLED 24P Shield works with Arduino | |||
| | |model=OLED 24P Shield | ||
| | |status=Published | ||
| | |module=Arduino | ||
| | |image1=Product-TEST-ARD-DIY-03.png | ||
| | |image2=Product-TEST-ARD-DIY-03.png | ||
| | |intro=SPI color display module demo page using minimal signal lines, suitable for resource-constrained embedded systems.(Standalone product 3) | ||
| | |highlights=* SPI interface saves MCU pins. | ||
| | * Supports partial refresh and common graphics drawing workflows. | ||
* | * Interface, parameters, and FAQ are all maintainable via backend. | ||
* | * Standalone product ID: 3. | ||
* | |hardware=Core signals include SCK, MOSI, CS, DC, and RESET; backlight is independently controlled. Do not apply 5V directly to 3.3V signal pins. | ||
|usage=# Connect power and SPI signals per the pinout table. | |||
| | # Configure chip select and orientation in the driver. | ||
# Run a solid color test first, then load the graphical UI. | |||
# Adjust SPI clock based on bus length. | |||
|faq=; Why is the screen all white? | |||
: Check reset, chip select, data/command pins, and initialization model. | |||
; What if the image has noise? | |||
| | : Lower the SPI clock and shorten the connection wires. | ||
# | |displayMode={{{displayMode|详情}}} | ||
# | |cardPage={{{cardPage|{{PAGENAME}}}}} | ||
# | |displaySize=3.2 inch | ||
| | |resolution=320 × 240 | ||
: | |interface=4-wire SPI | ||
; | |touch=Optional resistive touch | ||
: | |power=3.3V | ||
| | |dimensions=Approx. 92 x 60 mm (demo) | ||
| | |||
}} | }} | ||
<noinclude>{{#default_form:ProductPage}}</noinclude> | |||
Latest revision as of 10:59, 18 September 2026
Arduino
OLED 24P Shield
Published
SPI color display module demo page using minimal signal lines, suitable for resource-constrained embedded systems.(Standalone product 3)
Introduction
- SPI interface saves MCU pins.
- Supports partial refresh and common graphics drawing workflows.
- Interface, parameters, and FAQ are all maintainable via backend.
- Standalone product ID: 3.
Specifications
Specifications to be added.
Hardware
Core signals include SCK, MOSI, CS, DC, and RESET; backlight is independently controlled. Do not apply 5V directly to 3.3V signal pins.
Size
- Connect power and SPI signals per the pinout table.
- Configure chip select and orientation in the driver.
- Run a solid color test first, then load the graphical UI.
- Adjust SPI clock based on bus length.
FAQ
- Why is the screen all white?
- Check reset, chip select, data/command pins, and initialization model.
- What if the image has noise?
- Lower the SPI clock and shorten the connection wires.
Downloads
暂无Published资源，管理员可在产品表单中添加下载文件。