Arduino Display Controller

Edit Product

ESP8266

0.96" OLED Clock Board

Published

SSD1306, I2C, BLUE

Introduction

The A8266-096-Clock is a 0.96-inch OLED network desktop clock built around the ESP8266. It retrieves the time automatically from an NTP server over Wi-Fi, supports world time zones and daylight saving time, and can show the current weather, a 3-day forecast, device information and alarm reminders on the OLED. The unit is powered through USB-C and provides a built-in web configuration page, so no extra app is required - a phone or a computer is enough to complete network provisioning and parameter setup.

Specifications

Key Components

Component	Description
ESP8266 (ESP-12F)	Wi-Fi microcontroller running the main program; handles network, NTP and the web server
0.96" OLED	Blue SSD1306, 128x64 resolution, I2C address 0x3C
CH340C	USB-C to serial chip for power supply, firmware upload and 115200 serial output
WS2812B	On-board RGB LED for status, weather and alarm indication
SELECT button	Connected to GPIO16; a short press switches OLED pages; while ringing, a short press snoozes and a long press turns the alarm off
BOOT button	Connected to GPIO0; a 3-second long press shows the configuration hotspot information on screen
RST button	Resets the ESP8266
Expansion I/O headers	Headers on both sides expose the common ESP8266 GPIOs for further development

Hardware

Development Board包含主控区, 存储区, 显示连接器, 调试接口和扩展排针.所有跳线操作应在断电状态完成.

Size

1. Connect the debugger or USB data cable.
2. 选择对应工具链和Development Board配置.
3. Flash the interface self-test firmware.
4. Complete wiring and driver configuration per the target display module.

FAQ

What if unable to enter download mode?

Check boot button timing, USB driver, and data cable.

What if peripheral communication is unstable?

Verify logic levels, ground, bus speed, and terminal connections.

Downloads

暂无Published资源，管理员可在产品表单中添加下载文件。