2.42-inch OLED Display 128*64 (blue)

Edit Product

OLED Display

2.42-inch OLED

Published

128*64  SSD1309  24pin

Introduction

2.42" 128x64 OLED Screen, Multi-interface, 24Pin Soldering Flex Cable, Compatible with ESP32 / Arduino.

Specifications

Specifications to be added.

Hardware

1.Hardware Wiring

2.42" OLED (SSD1309, IIC Interface) ↔ Arduino Board

You need to use the OLED 24P Shield adapter board, together with an Arduino-compatible mainboard. You can freely choose either ESP8266 Arduino Board or ESP32 Arduino Board.

2.Compilation & Upload

Open the sample code, compile it, upload the code, and perform the final test.

Size

1. Connect power and the I2C bus.
2. Scan and confirm the device address.
3. Load the driver matching the resolution.
4. Draw text and graphics to verify orientation.

FAQ

What if the address cannot be scanned?

Check power, ground, SCL/SDA reversal, and pull-up resistors.

What if the display content is misaligned?

Confirm controller model, resolution, and page addressing mode.

Downloads

暂无Published资源，管理员可在产品表单中添加下载文件。