OLED 30P Shield: Difference between revisions
From olighker
More actions
No edit summary |
No edit summary |
||
| Line 12: | Line 12: | ||
resources for other expansions. | resources for other expansions. | ||
|specs={{{!}} class="wikitable" | |||
{{!}}+Interface Description | |||
!Pin | |||
!Direction | |||
!Function | |||
{{!}}- | |||
!3V3 | |||
!Power output | |||
!<div>Provides 3.3 V power to the OLED display</div> | |||
{{!}}- | |||
{{!}}GND | |||
{{!}}Power | |||
{{!}}Common ground | |||
{{!}}- | |||
{{!}}SDA | |||
{{!}}I2C data | |||
{{!}}<div>I2C data I2C data line, connected to the main board's SDA</div> | |||
{{!}}- | |||
{{!}}SCL | |||
{{!}}I2C clock | |||
{{!}}<div>I2C clock line, connected to the main board's SCL</div> | |||
{{!}}} | |||
|hardware=[[File:OLED 30P Shield-800-600-4.jpg|center|thumb|800x800px]] | |hardware=[[File:OLED 30P Shield-800-600-4.jpg|center|thumb|800x800px]] | ||
|usage=[[File:OLED 30P Shield-800-600-3.jpg|center|thumb|800x800px]] | |usage=[[File:OLED 30P Shield-800-600-3.jpg|center|thumb|800x800px]] | ||
Revision as of 23:30, 17 September 2026
Arduino
OLED 30P Shield
Published
Arduino
Introduction
1.OLED 30P Shield is a display expansion board (Shield) from OLIGHKER that complies with the Arduino interface standard. It carries an onboard FPC 30P connector for directly attaching OLED displays with an FPC 30P interface, and works with any main board that supports the standard Arduino interface.
2.The shield communicates over I2C and occupies only 4 main board pins (3V3, GND, SDA, SCL) to power the OLED display and transfer data, preserving the board's I/O
resources for other expansions.
Specifications
| Pin | Direction | Function |
|---|---|---|
| 3V3 | Power output | Provides 3.3 V power to the OLED display
|
| GND | Power | Common ground |
| SDA | I2C data | I2C data I2C data line, connected to the main board's SDA
|
| SCL | I2C clock | I2C clock line, connected to the main board's SCL
|
Hardware
Size
FAQ
- Why is the screen all white?
- Check reset, chip select, data/command pins, and initialization model.
- What if the image has noise?
- Lower the SPI clock and shorten the connection wires.
Downloads